Engine Tolerances

Today I have posted a new page, 'Engine Tolerances'. This shows a table of the dimensions and tolerances I am using to inspect the engine, and will build up as I complete the inspection.

I started by measuring the bores. I now know that Amelia's bores are 20 thou oversize, but that they are looking good with little wear.

I've measured up the pistons, rings & pins. The results are shown on the 'Engine Tolerances' page.

In line with a current topic in the AOMCC forum, I will weigh the pistons & pins - though I don't know what I will compare them with! or what I will weigh them with!