Model A - repairing threads

It's a wet day here in Norfolk, and I have some domestic stuff to do in the workshop so while I'm at it I might get distracted...

I'm looking at the workshop layout with a view to getting a bike lift in there, so I have shuffled them around and the Model A happens to be accessible, so we will have a look at a couple of loose ends. The front mudguard has been hanging off for a while (and still is) because there are a couple of dubious threads in the forks - one, a broken bolt, and then two other threads that are just fouled.

Here's the broken one - I have put a 1/8" hole through this broken 1/4" bolt, to see if it will come out with an Easy-Out. They never do, but I have to drill the hole anyway!

Of course, it didn't come out and I moved through the drills until I was one size under tapping size for 1/4" CEI. I then applied the 1/4" CEI taper tap and used it to clear the thread - it moved the remains of the bolt:

Next stop, same problem at the back. I made the mudguard & rack fasteners a while ago and could only fit one side, because I found someone had broken one of the 3/8" bolts in the frame lug, drilled and tapped it something like 5/16" and put a new bolt in. Today, I removed the broken 3/8" stump using a diamond burr in the Dremel and chasing out with a 3/8" CEI taper tap, so this shot shows it all back together with the stand spring fitted at last:

I also took the opportunity to chase out the chain adjuster threads. Grovelling about on the floor makes me realise that a hydraulic lift would be a nice addition to the workshop!

Back at the front, I now have both sides of the mudguard stay fitted - to cut the mudguard, I need the centre bracket and the front stand fitting - unfortunately I have run out of 5/16" screws, so that's the next job.

Comparing the next picture with my picture above, you can see I have the mudguard stay too far forward: