FH - rocker box

It's pouring with rain here today so badly that I can barely take the dogs out, so I've taken a little while to come and varnish an oak window sill and fit the rocker box to the Huntmaster. 

We start with Wellseal on the rocker box gasket faces and stick the gaskets in place. Next we'll put another coat on the cylinder head gasket faces and manoeuvre the rocker box into place over the pushrods.

I'm using a small USB camera connected to my phone to have a look in some of the small spaces around the top of the engine. The camera is small enough to go down towards the pushrod tunnels so that we can verify that the bottom end of the push rods are sitting in the tappets properly.

The camera fits through the inspection hole in the top of the rocker box and through the big spaces at the front and back to allow us to see whether the push rods are engaging with the rockers properly. You can get a small screwdriver in front or rear to nudge the pushrods into place.

With a bit of fiddling, I got the rocker box down and bolted. These bolts are actually supposed to have shakeproof washers so I shall have to change them later but the gaskets are pulled down properly. I've also fitted the rocker box oil lines.

So this all went pretty well except for one thing. Whilst the rocker box is down and I've managed to adjust the exhaust rockers to a reasonable clearance, there is no way that I can get the adjusters far enough into the rockers to bring the inlet rocker clearance to specification. I'm not sure what's wrong with this, it might be worn adjusters, it might be worn pushrods...

Wish I had had the foresight to measure the pushrods before I started...