There's a lot of splits in sheet metal components on this bike - not surprising after 95 years of corrosion & vibration. This is the top engine plate cover over the dynamo, and one of the bolt loops is missing. I'm replacing it with a bit of sheet cut from the side of a dead dishwasher - 0.5 mm thick:
One of the benefits of having quite a small TIG welder is that you can do tiny little things like this - this was set at 15 amps:
This is the front engine plate cover. Despite the fact that the one in the parts book is slightly different (it has four bolt loops) it appears Ariel modified this part without reflecting the change in the parts book illustration - I'm saying this because others I've seen are the same as mine - go and look at the one in this post, about the dynamo clamp.
No comments:
Post a Comment