Lots and lots of little jobs today. I've put the front wheel back together and back in the bike, noticing that the centre stand is off the deck when the front wheel is high enough to come out - I used the scissor lift to get the bike high enough; that centre stand is going to have to come off again.
There's a separate post on the work I've done on the fuel tank, but there are some other bits to talk about here.
These 2 BA screws hold the front engine plate cover in place - I must find a better way of holding small screws for trimming:
Doesn't that look nice:
By the way, I used a small flap wheel to clean the paint out of the front axle clamp hole:
No comments:
Post a Comment